|
> You are here:
Home /support /secure /install /Install Tutorial - Step 17
Previous - Next
Step 17
The next part of the Setup Wizard is the Operator Display test. Since the displays were connected in Step 6, click Next and watch the displays.
After a few seconds (depending on how many dialers you have) all the displays around the room should display a station number.
If the displays do not show any information then check to make sure the 25 pin Operator display cable is connected securely to the dialer. If only one display is blank then ensure the cable is plugged securely into that display.
If the display is still not working, switch that display with a known working display and run the Operator Display test again by clicking on Previous and then Next.
NOTE: Do not extend the spider cable or alter it in any way without first consulting MarkeTel Technical Support.
Previous - Next
|
